We install ovens, electric cooktops and induction units across Redcliffe, the peninsula and Moreton Bay. Every unit is wired in by a licensed electrician and tested before we leave, and we check the switchboard first to make sure the circuit can carry it.
Andrew holds electrical contractor licence 91921 and has 16 years on the tools. You get a free, fixed quote before any work starts, and you deal with him direct.
What's included
- Wall ovens, under-bench ovens and freestanding cookers
- Electric and induction cooktops
- A check of the circuit, cable and switchboard before we quote
- A new circuit where the existing one cannot carry the new unit
- Removal and safe disconnection of the old unit
- Safety switch protection checked on the circuit
- Every unit tested and run through with you before we leave
- A free, fixed quote before work starts
Why do we check the board first?
A new oven or cooktop can draw a lot more power than the one it replaces. Induction units are the common one. They heat fast, and they load a circuit harder than an old coil cooktop did. If the circuit, the cable or the switchboard behind it was set up for the old unit, the new one may not run properly, or may overload the circuit.
So before we quote, we look at what is feeding the kitchen. If it can carry the new unit, we wire it in. If it cannot, we tell you what has to change, whether that is a new circuit from the board or a board that needs upgrading first. That is a switchboard upgrade, and it is quoted separately, fixed, so there is no surprise on the day.
What happens on the day
We isolate the power, disconnect and remove the old unit, and set the new one in place. Then we connect it to its circuit, check the connections and the safety switch protection, and test it. Last, we run it with you so you know it is working.
Most ovens and every cooktop and induction unit we fit are wired to a circuit of their own, not plugged in to a spare power point. If your kitchen is part of a bigger job, we can do the power points and downlights in the same visit.
Why it has to be a licensed electrician
In Queensland, electrical work has to be done by a licensed electrician. That covers connecting a hardwired oven or cooktop, so please do not do it yourself, or hand it to someone who is not licensed. A bad connection on a high-load appliance is a fire risk.
There is a practical reason as well. Manufacturers generally expect a licensed installer, and that is what keeps the warranty valid. Check your warranty terms, and keep the invoice from your installer with the paperwork. Our licence number is 91921.
What affects the quote?
We quote it free and fixed, after we have seen the kitchen. We do not give a figure over the phone. What moves the quote:
- Whether the existing circuit and cable can carry the new unit.
- Whether the switchboard needs work first.
- How far the cable has to run from the board to the unit.
- Whether it is a straight swap of the same type, or a move from a coil cooktop to induction, or a new position.
- How many units go in at the same visit.
If the new unit needs a different cutout in the bench or cabinet, that is a job for your cabinet maker or kitchen installer, and we will tell you early so the two jobs line up.
Why Fins Up for kitchens
We work in kitchens on new builds and renovations, and we do the electrical side of a renovation without handing you to someone else. We are open 24 hours Monday to Saturday and travel up to 60km from Scarborough. We hold public liability insurance and have a 5.0 star Google rating.
Need oven and cooktop installation? Ring us.
Licensed electrician, licence 91921. Free quote before any work starts. Open 24 hours Monday to Saturday.
Common questions
Can I put an induction cooktop on my existing circuit?
Sometimes. It depends on the circuit, the cable and the switchboard behind it. We check them first and tell you if anything has to change before the cooktop goes in.
Do I need an electrician to replace my oven?
If the oven is hardwired, yes. In Queensland a hardwired connection has to be made by a licensed electrician.
Will a licensed install keep the manufacturer warranty valid?
Manufacturers generally expect a licensed installer, so a licensed install is what protects the warranty. Check your warranty terms, and keep the invoice with them.
Do you take the old oven or cooktop away?
We disconnect it safely and remove it. Tell us when you book so we can plan it into the visit.