An outdoor power point needs a weatherproof outlet with an IP rating that suits where it sits, and it has to be protected by a safety switch (RCD) at the switchboard. It must be installed by a licensed electrician, because in Queensland all electrical work is licensed work. Get the spot right first, then the outlet type follows.
What does the IP rating on an outdoor power point mean?
IP stands for Ingress Protection. It’s an international code (IEC 60529) that tells you how well an enclosure keeps things out. It has two numbers:
- The first number is protection against solids, from fingers down to fine dust. Higher means tighter.
- The second number is protection against water, from dripping, to spray, to jets, up to being submerged.
A point under a deep patio roof doesn’t face the same weather as one on an open fence by the pool pump. The more exposed the spot, the higher the water rating you want. We match the outlet to the location rather than fitting the same box everywhere.
Why does an outdoor point need a safety switch?
Outside is where water, wet hands, bare feet and damaged leads all meet. A safety switch (also called an RCD) watches for current leaking to earth and cuts the power in a fraction of a second. Circuit breakers protect the wiring. Safety switches protect people.
In Queensland, safety switches have been compulsory on power point circuits in new homes since 1992, and on power and lighting circuits in homes built since 2000. When new power points are added, the circuit must have safety switch protection. If your board doesn’t have one on that circuit, it gets fitted as part of the job. Our switchboard upgrades page covers that work.
Where should an outdoor power point go?
Think about what you’ll plug in, then put the point near it. Common spots:
- Beside the barbecue or outdoor kitchen.
- On the patio for a fan, heater or TV.
- Near the garden for a pump, pond filter or lights on a timer.
- At the front of the garage or carport for a pressure washer or tools.
- Near where a boat or caravan parks.
A point placed right means no extension leads snaking across wet grass. Mount it high enough to stay clear of pooling water and garden sprinklers, and out of the way of hoses.
Does living near the coast change anything?
On the Redcliffe peninsula, salt air is hard on anything metal left outside. Cheap fittings can corrode, and lids that stop sealing let water in. For exposed spots near the water we pick outlets made for outdoor use and check the cover and seals are sound. It’s worth checking older outdoor points for cracked covers or rust too. If one looks tired, our repairs and fault finding service can replace it.
Can I install an outdoor power point myself?
No. In Queensland, installing a power point is electrical work and only a licensed electrician can do it. The Electrical Safety Office lists installing a power point as a job you should never DIY. Unlicensed electrical work is illegal, and if it causes a fire your insurer may refuse the claim.
Outdoor points carry extra risk because they sit in the weather. A poorly sealed outlet or a cable run without proper protection can leave something live that you only find out about when it fails.
How long does it take to put in an outdoor power point?
It depends on how far the cable has to travel and what it has to get through. A point on an outside wall straight below an accessible roof space is fairly quick. A point out on a fence, a garden bed or a detached structure needs a cable run, sometimes underground, and that’s a bigger job.
Fins Up Electrical quotes free and fixed before we start. Andrew looks at the spot, the switchboard and the run, and tells you what’s involved. We’re open 24 hours Monday to Saturday and work across Moreton Bay. Licence 91921. See our power point installation page for more.
Want this sorted? Power point installation from Fins Up.
Licensed electrician, licence 91921. Free quote before any work starts. Open 24 hours Monday to Saturday.
Common questions
What IP rating should an outdoor power point have?
It depends on how exposed the spot is. A point under cover faces less water than one on an open wall or fence, so the more exposed it is, the higher the water rating you want.
Do outdoor power points need RCD protection?
Yes. In Queensland, power point circuits need safety switch protection when new points are added, and outside is where that protection matters most.
Can I use an indoor power point outside if it’s under cover?
An outlet outside the house should be one designed for outdoor use. Even covered areas get blown rain, humidity and hose spray.