Blog

Safety switch tripping when it rains

· 3 min read · Fins Up Electrical, licence 91921

5.0 on GoogleLicence 91921Open 24 hours, Mon to SatFree quotes

A safety switch tripping when it rains almost always means water is getting into your electrics somewhere outside. The usual spots are outdoor power points, sensor and garden lights, an underground cable to a shed or pool, or a roof leak dripping onto a light fitting. Keep away from wet fittings and get a licensed electrician to find where the water is getting in.

Where does rain usually get in?

  • Outdoor power points with cracked or missing covers, or ones that aren’t rated for outdoors at all.
  • Sensor lights and floodlights on eaves, where the seals have perished in the sun.
  • Garden and driveway lights sitting low in garden beds where water pools.
  • Underground cable to a shed, granny flat or pool pump that’s been nicked by a shovel or has a poor joint.
  • Roof leaks that run along a beam and drip into a downlight or a junction in the ceiling.

Near the bay, salt air eats away at outdoor fittings faster than it does inland, so seals and covers that look fine can still be letting water in.

What can I check without touching anything?

Have a look, not a fiddle. From a safe distance, check:

  • which circuit tripped (the safety switch has a 'T' or 'Test' button, and circuits are usually labelled)
  • outdoor covers that are cracked, open or missing
  • fittings with water marks, rust or bugs inside the lens
  • leads or power boards left outside
  • any brown stain or drip on the ceiling near a light

Unplug anything plugged in outside, then try resetting the switch once. If it trips again while it’s still wet, leave it off.

Will it fix itself when things dry out?

It might hold once the fitting dries. That doesn’t mean the problem’s gone. The water got in once, and it left corrosion and dirt behind. Next storm, it’ll trip again, and each time the connections get a bit worse.

The bigger risk is a fault that doesn’t trip. If a circuit isn’t covered by a safety switch at all, water in a fitting can make metal parts live with nothing to cut the power. The Electrical Safety Office recommends safety switches on every circuit for exactly this reason.

When is it an emergency?

Stop and call for help straight away if:

  • you feel a tingle from a tap, gutter, fence or anything metal
  • you see sparking or smell burning
  • water is pouring through a light fitting or around the switchboard
  • a powerline is down

For a tingle from a tap or metal fitting, the Electrical Safety Office says to call your distributor, which on the peninsula is Energex on 13 19 62, and not to touch the switchboard or meter box until it’s made safe. For fallen powerlines, call 000 or 13 19 62 and stay well clear.

Why does it trip in some storms and not others?

Wind direction matters more than people think. Rain blowing in from the bay side can hit eaves, a patio light or a side wall that stays dry in a normal shower. If your trips only come with storms from one direction, that is a strong clue about which side of the house to look at.

Heavy rain also lifts the water table in garden beds and around footings. An underground cable joint or a low garden light that sits dry most of the year can end up under water for a few hours. Write down when it happens and what the weather was doing. It saves time when we test.

How do we fix it for good?

We find the wet fitting or cable by testing each part of the circuit, then fix the cause, not only the symptom. That might mean swapping old points for proper weatherproof ones, resealing or replacing outdoor lights, or replacing a damaged underground run.

Fins Up Electrical does outdoor power and lighting and general repairs around Scarborough, Redcliffe and the rest of Moreton Bay. We’re open 24 hours Monday to Saturday, and we will give you a free quote before starting.

Want this sorted? Electrical repairs from Fins Up.

Licensed electrician, licence 91921. Free quote before any work starts. Open 24 hours Monday to Saturday.

Common questions

Why does my power trip only in heavy rain?

Light rain may not reach the problem spot, but heavy or wind-driven rain gets into gaps under eaves and into poorly sealed outdoor fittings. That points to a specific outdoor fitting or a roof leak.

Can I tape up or seal an outdoor power point myself?

Don’t. Opening, sealing or replacing a power point is electrical work and must be done by a licensed electrician in Queensland. Keep clear of it and call one.

Is it safe to use outdoor power points after rain?

Not if they’ve been tripping. Leave them unused until an electrician has checked them, and never use one that looks wet inside or has a broken cover.

Sources

The service